#181

Pin-Type

Strap Bolt

 

 

MADE TO ORDER

  • Click For Available Resources

Strap Thickness:

Diameter of Threaded Rod:

Materials:

  • 1/4"
  • 3/16"
  • 1/8"
  • 11 gage
  • 12 gage
  • 16 gage

Strap Length:

  • Specify the length of the strap.
  • 1/2" minimum of steel between the end of the anchor and the start of the pin is recommended.

Strap Width:

  • 1/4"
  • 3/8"
  • 1/2"

Length of  Threaded Rod:

  • Specify the length of the threaded section.
  • Threaded rod is welded 1" onto the strap unless otherwise specified.

Diameter of Pin:

  • 1/4"
  • 3/8"
  • 1/2"
  • Stainless Steel
  • Hotdip Galvanized After Fabrication

Note:

  • Specify the location of the pin from center of pin to the end of the strap.
  • Pins are available loose or welded in place.
  • Nut & washer are included unless otherwise specified.
  • Heckmann Building Products recommends using only Stainless Steel for stone anchorage.
  • 1-1/4" recommended.
    (allow at least 1/4" of steel on each side of the pin)

Length of Pin:

  • Specify the overall length of pin.
  • Pin is usually 3" minimum length.