Mobile Nav Open Mobile Nav Close
75 Pos-I-Tie® ThermalGrip® Washers
75 Pos-I-Tie® ThermalGrip® Washers

Roll over image to zoom in

ThermalGrip® CI Washers (610)

Part Number: 610

Thermal-Grip® washers are designed for use with the Pos-I-Tie® Veneer Anchoring System. Prongs enable pre-spotting into rigid insulation for fast on-the-wall fastener assembly. The ThermalGrip® washer allows the masonry tie to also act as a Continuous Insulation fastener to prevent wind blow-off during construction.

Also available to

Buy Online

Features and Benefits

  • 2" diameter plastic washer with solid cap design (no keyholes)
  • Stiffened center “bullseye” ring prevents fastener pull-through
  • Flexible perimeter compresses on surface
  • Prongs pre-spot into insulation
  • Carbon black UV stabilizers
  • Use with Pos-I-Tie® Veneer Anchoring System
  • Flattens on surface of insulation

Materials/Finishes

  • Proprietary Plastic

#610 Thermal-Grip® Plastic Washers 

Used with the Pos-I-Tie® Brick Veneer Anchoring System. These versatile washers are 2” in diameter and provide exceptional wind-loading resistance to help prevent blow-offs. Using the Thermal-Grip® Washers with the Pos-I-Tie® Barrel Screws combines two steps into one by securing the insulation board with the Veneer Anchor (vs. securing the insulation with screws/washers and then adding the brick ties) thus saving time and money.

The washer is slipped onto the Original Pos-I-Tie® on the jobsite for easy installation. Using this method, the number of penetrations through the insulation are greatly reduced there reducing thermal bridging*. Combining the Pos-I-Tie® with the Thermal-Grip® washer reduces the required ci washer/screw fasteners by up to half. The Thermal-Grip® washers are designed to compress on the insulation surface effectively sealing the fastener penetration against air and moisture infiltration.

One Size Only - 2" diameter

Note: $200 minimum total per order

Prongs enable pre-spotting into insulation for easy installation of the Pos-I-Tie® Barrel Screw.

* see Heckmann Pos-I-Tie® Thermal Clip product for additional prevention of thermal bridging.


Pos-I-Tie Original

The Original Pos-I-Tie® Brick Veneer Anchoring System (75)

Downloads

Pos-I-Tie® Installation Tools

Downloads

Pos-I-Tie® Triangle Wire Ties

Downloads

ThermalGrip® CI Washers (610)

Downloads

Pos-I-Tie Large Steel EPDM CI Washer (75-SW)

Downloads

75-PW - Plastic CI Washers for Pos-I-Tie®

Downloads

Help from the Experts