Roll over image to zoom in
Pos-I-Tie® ThermalClip® (75-TC)
Part Number: 75-TC
The Pos-I-Tie® ThermalClip® is designed for use with the Original Pos-I-Tie® Veneer Anchoring System. This new breakthrough in masonry construction adds thermal-break technology to all the advantages of the Original Pos-I-Tie® Veneer Anchoring System. It has passed NFPA 285 Testing as part of the CavityComplete® Wall system.
The clip snaps into the Pos-I-Tie® barrel loop creating a thermal break between the wire tie and the barrel. This break also allows for stainless wire ties to be used with the Zamak barrel screw.
Use #282-N Pintle Wire Ties with the ThermalClip®
Resources
75 TC ThermalClip® Submittal Sheet
2D Cad TCFeatures and Benefits
Snap on design locks ThermalClip® to the barrel loop creating a thermal break between the wire tie and the Pos-I-Tie® barrel screw
Creates a dissimilar metals break allowing the use of stainless-steel ties or stone anchors with the Original Pos-I-Tie®
Allows for vertical adjustment of 1-1/4" above and below the barrel
Transfers compression and tension loads to structural backup
Offers speedy, cost-saving installation
Proprietary Plastic Material
Decreases thermal transfer
Has very low thermal conductivity, over 100 times less than metals such as steel
Highly flame resistance with a UL 94 V-0 rating
Tolerant in “freeze-thaw” conditions and with alkaline in mortar
Prevents galvanic reaction from dissimilar metals
Compatible with Double Pintle Wire Ties and ThermaClip® Stone Anchors
Materials/Finishes
Proprietary plastic
Pos-I-Tie® ThermalClip® System
Pos-I-Tie® ThermalClip® System (75-TC)
Downloads
Submittal Sheet
2D C.A.D. Details
Pos-I-Tie® Installation Tools
Downloads
Pos-I-Tie® ThermalClip® (75-TC)
Downloads
Pos-I-Tie Large Steel EPDM CI Washer (75-SW)
Downloads
75-PW - Plastic CI Washers for Pos-I-Tie®
Downloads
