Mobile Nav Open Mobile Nav Close
78 S
78 S

Roll over image to zoom in

Pintle Split-Bend Stone Anchor (78-S)

Part Number: 78-S

Made To Order

For use with the Pos-I-Tie® ThermalClip® anchoring system.

1/8" or 3/16" thick stainless steel 2" wide.

Specify anchor length and split bend length.

(Note! Anchor length starts 3/4" out from the backup wall. See submittal sheet for details.)

#78 Pintle Stone Anchors for Pos-I-Tie® ThermalClip® system.

Custom Made: For use with the Original Pos-I-Tie® Barrel Screw and the ThermalClip®. 1/8” x 2” wide only. Stainless Steel.

Pintle stone anchors are notched to fit in the ThermalClip® with the Original Pos-I-Tie® system. Specify Length from bend in pintle to OD of anchor.

1/8” x 2” wide with 1” splitbends

Vertical adjustment 1”

Ultimate Design Loads compression and tension

¼” extension: 160 lbs

½” extension: 64 lbs

¾” extension: 40 lbs

1” extension: 28 lbs

Installation of the Pos-I-Tie® screw should be within ¼” below joint to achieve the best load.

Note: $400 minimum total per order

Material Specifications 

Stainless Steel: Sheet metal anchors and ties: ASTM A 167, ASTM A 666, ASTM A 240/A240M AISI Type 304.

Wire ties and anchors: ASTM A 580 AISI Type 304 (AISI Type 316 available upon request)

Pos-I-Tie® ThermalClip® System

Pos-I-Tie® ThermalClip® System (75-TC)

Downloads

Pos-I-Tie® Installation Tools

Downloads

Pintle Split-Bend Stone Anchor (78-S)

Downloads

Pintle U Stone Anchor (78-U)

Downloads

Pintle Z Stone Anchor (78-Z)

Downloads

Pintle Pin Stone Anchor (78-P)

Downloads

Pintle Wire Tie for ThermalClip® (282-N)

Downloads

ThermalGrip® CI Washers (610)

Downloads

Pos-I-Tie Large Steel EPDM CI Washer (75-SW)

Downloads

75-PW - Plastic CI Washers for Pos-I-Tie®

Downloads

Help from the Experts